Chapter 10 Instant Internet unit configuration, support, and diagnostics 279Using the BayStack Instant Internet Management Software Version 7.11Figure 123 Prompt to restore users and groups6 If you want to restore the user and group configurations in Admin, click Yes;otherwise, click No.7 In the Setup main window, click Save and Exit.Changing the unit configurationBefore you change the Instant Internet unit’s configuration, you should back upthe current configuration. If the changes you make cause problems, you canrestore the original configuration using this backup file. Refer to “Saving andrestoring unit configurations” on page 277.To change the Instant Internet unit’s configuration:The Setup program first ensures that the unit is functioning properly, and thendisplays the main Setup window.Refer to the appropriate sections that follow for instructions on changing theInstant Internet unit’s configuration. Change the information as your ISP or as aNortel Networks support representative advises. After each change, click Saveand Exit. You are then asked:Start Setup, and if prompted, select a unit to configure.Note: If you forget your password and need to configure the unit, youcan do so by resetting the DIP switches on the back of the unit. Fordetails, refer to the hardware manual for your Instant Interent unit.
