Nortel NAC User Manual

Contents

16 Preparing the systemDescribing the system requirementsStandard 1.0 Network Administration Center November 1998User Guide SupplementDescribing the system requirementsIntroduction This section describes the hardware and software componentsthat you require to run NAC 2.5.NAC 2.5 uses the same hardware components as NAC 2.However, a new LAN transceiver cable has been added to NAC2.5.Equipment andmaterial listThe following table lists the equipment and materials requiredby NAC 2.5.Equipment ContentsNAC 2.5 SNN • Motorola MVME167-34 single board computer with M68040 33 MHzCPU• Motorola MVME332XT/XTS eight-channel asynchronous I/O board(maximum of five)• NT7D62CA Mass Storage Unit (contains 1 Gbyte hard disk drive and600 Mbyte tape drive unit)• NT7D64AA/DC Application Module power supply (AC or DC)• NTD19SA Application ModuleCables • three multiport cables (NT8D96BE) for each MVME332XT/XTSasynchronous communication controller• LAN transceiver cable (NT7D47EA)• external input/output cablesWorkstations • VDT-type (DEC VT520, DEC VT420, DEC VT320, DEC VT220, orterminals which are 100% compatible• PC running Reflection 4+ for DOS terminal emulator and directlyconnected to the NAC 2.5. All PCs supported by Reflection aresupported by NAC 2.5.• PC running MTE 9 and connected to the NAC 2.5 (either directly orthrough a LAN connection). For more information on PCrequirements, refer to the MTE 9 User Guide (P0881398).