Service Manual ALS/XLS 20x/256/27202/2019 | 00 228Fault descriptionTYPES OF STATUS MESSAGESError messagesIf an error occurs, the machine stops immediately and displays an error message on the operatorpanel.The format for error messages is as follows:[181] Example of an error message:5144 = status number; the message can identified more easily with this number.“Rewinder init” = status text; a short description of the error.If an error occurs that is not described here: Press the button to delete the message. Switch the machine off, wait 30 seconds and switch it back on.WarningsWarnings indicate less severe status than error messages. The labelling is not interrupted by awarning.Warning can occur both in dispensing mode and in online setting mode.Warning format:[182] Example of a warning in dispensing mode:„Material low“ = Warning text; a short description of what has caused the warning.Setting back a warningIn dispensing mode: Press the button (works earliest with firmware versions > 1.10).In online setting mode: Switch to dispensing mode. To do so, press the buttons + . Press the button (works earliest with firmware versions > 1.10).In both modes: Send the Easy-Plug command #!CLRW to the machine.If more than one warning is active at a time, the highest prioritised warning appears at first;if thit one is set back the next one appears, and so on.Status num: 5144Rewinder initONLINEMaterial low
