113.3.3 Calibration AdjustBalances with InCal TM contain software which allows theinternal calibration mass to be adjusted + 100 divisionsat full scale capacity. This permits calibrating the balanceusing an external Class I mass which is traceable to acertified standard.Procedure• Perform the internal calibration procedure of para-graph 3.3.1.• Press # button to zero the balance.• Place a Class I mass equal to thespan calibrationvalue of the balance. Note the reading on the bal-ance and see if the balance indicates the exactweight or indicates a higher or lower reading. If thereading is higher or lower, proceed.• Press the Setup button, CAL is displayed.• Press Enter button, CAL TYPE is displayed.• Press button until, CAL ADJ is displayed.• Press Enter button, CAL ADJ 0 should be displayed(0 is factory setting).NOTE: Balance will retain last CAL ADJ setting.• Press or button until desired number isdisplayed.• Press Enter button, SAVED is momentarily dis-played, then display indicates LOCK.• Press Enter button, LOCK ON or LOCK OFF is dis-played.• Press or button and select either LOCKON or LOCK OFF. LOCK ON is normally used inlegal for trade applications. When set ON, and legalfor trade is enabled in the balance, the calibrationadjust is disabled and whatever setting was enteredwill remain in the balance.• Press Enter button, SAVED is momentarily dis-played, then EXIT is displayed.• Press Enter button, display returns to WEIGH mode.• Perform the internal calibration procedure of para-graph 3.3.1. The value entered as an adjustment isnow stored. Place the calibration mass on the panand check. Repeat procedure if further correction isrequired. The display must agree with the mass usedfor calibration.• To return to factory setting, follow procedure aboveand set CAL ADJ to 0.SetupUse keys to change, press EnterChangeSetupUse keys to change, press EnterChangeSetupUse keys to change, press EnterChangeSetupUse keys to change, press EnterChangeSetupUse keys to change, press EnterChangeSetupUse keys to change, press EnterChangeModeUnitsSetup PrintEnterSetupUse keys to change, press EnterChangeModeUnitsSetup PrintEnterStableg