Oak Telecom VoxBox User Manual
Also see for VoxBox: User guide
                                                                                                                                                                     | |
Contents
| 
DTMF ProgrammingChapter 4: DTMF Programming4.1 GeneralYou can program the unit using:z A telephone – by means of DTMF tonesz A computer – by means of the designated Voice Mail Maintenance software(see Chapters 5 and 6). NOTEYou will hear a confirmation tone every time you enter a programming command.4.2 Entering and Exiting the Programming Mode NOTEThe unit is unable to handle calls when in the programming mode.¾ To enter the programming mode:.1 Connect a PBX analog line to the unit.2. Call the PBX analog line from any touch-tone telephone.3. Wait until the unit answers and plays the opening menu.4. Dial *900.5. Dial the System Administrator’s password (default: 1234) to enter theprogramming mode.¾ To exit the programming mode:Dial *900 or do not dial any number for a consecutive one minute. NOTEIf you exit the programming mode by dialing *900, the unit plays the opening menu. Youcan then check the changes that were made to the system.4.3 First Time ProgrammingWhen programming a unit for the first time, follow this checklist:1. Call from a touch-tone telephone to the unit. You will hear the defaultmessage (system message 000 – see Chapter 12).2. Dial *900 and the administrator password (default: 1234) to enter theprogramming mode.3. Set the PBX parameters according to Paragraph 4.3.1 to ensure the properoperation of the unit with your PBX.Voice Mail and Auto Attendant System Installation and Programming Manual 4-1 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine