DTMF Programming4. Set the unit’s real-time clock according to Paragraph 0.5. Set the system schedule according to Paragraph 4.3.3.6. Create mailboxes according to Paragraph 4.4.1.7. Define a notification type for each mailbox according to Paragraph 4.4.3.8. Define notification parameters (i.e. message light on and message light offand interval between ring notification) according to Paragraph 4.4.3.3.9. Record and program script menus for the Automated Attendant according toParagraph 4.4.4. Make sure you define the mailboxes before buildingAutomated Attendant script menus.4.3.1 Defining PBX ParametersTo integrate the unit with your PBX, apply the PBX parameters to the unit.To obtain your current PBX parameters, check your PBX User’s Manual or thecurrent PBX setup configuration.To configure the unit to detect the in-band DTMF protocol sent by your PBX,refer to Chapter 7. NOTEDo not forget to enter programming mode by dialing *900 and the administratorspassword before using the programming commands.Table 4-1 presents the commands you must enter to apply the PBX parameters tothe unit.Voice Mail and Auto Attendant System Installation and Programming Manual 4-2
