48 Océ CS 5050/5070 User ManualSelecting a colour modeColour mode gives you the option of printing in colour or monochrome.tttt To choose a colour mode1 Press Setup/Print Mode/Colour Mode.2 Choose Colour or Mono.3 Press OK.Selecting quality modesYou can select five print quality modes, depending on the type of image youare printing (i.e. line art or photographs).Draft A single-pass mode that optimises printing speed over quality. Useful asa check for position, layout, colour, etc., but not for finished quality images.Production A two-pass mode that gives fast, average-quality prints on bondpaper. Use it for line drawings or images with small areas of fill and large areasof white space.Note: Draft and Production modes are suitable for line drawings (CAD). Thesemodes are not recommended for printing images, because bleeding may occurin areas of heavy fill or dark shading.Quality A three-pass mode that gives fast, better-than-average-quality printson paper media.Photo A four-pass mode that optimises quality over printing speed, used forhigh-quality continuous-tone images.User-defined This option lets you select the number of print passes, the printdirection, and the carriage speed.Note: Use multi-pass modes for continuous tone images, blends, and solid fills.Because these modes split inking into three or four passes, it reduces printanomalies such as banding (stripes through fills) and over-inking. However, ittakes longer to print. Experiment with different modes to pick the best one foryour needs.