Use the Océ TDS400 to print 25How to turn on and turn off the OcéTDS400 printerTo turn on the system: turn on the printer. turn on the scanner (see page 49). turn on the controller(see page 26).When you turn on the system, it is ready for operation. In this state, themachine is in the stand-by mode.If the system is not in use for more than 1 minute, the operator panel returnsautomatically to the stand-by mode. The operator panel of the scanner isactivated in the following conditions: you feed an original a button on the operator panel is pressed Turn on the printer1 Set the ON/OFF switch at the rear of the printer to position ‘1’ (see figure 5).If the power supply is connected, the green switch lights.[5] On/off switch of the printerNote: When ‘Ready’ is displayed on the operator panel, the printer is ready foruse.
