Use the Océ TDS400 to print 29Manual feedThere are two possibilities to select manual feed: via remote control commands added to the print file (by means of PlotDirector or drivers). choose ‘manual feed’ on the scanner operator panel.[6] Manual feedIf you want to use manual feed, you must:1 program the media settings (material and feed time out) on the printer2 send the file3 feed the sheet of material4 hold the material until the printer pulls in the first part of the material.If you select manual feed, the printer will inform you to feed the sheet into theprinter. There is a time out between 1 and 10 minutes. Default is 1 minute. Set the time-out for manual feedDefault is 1 minute.1 Press ‘on line’ to put the printer off line.2 Select the ‘Media settings’ item with the or button.3 Press ‘next/select’ to enter the ‘Media settings’ menu.4 Select ‘Manual feed’ with the or button.5 Press ‘next/select’ to enter the ‘Manual feed’ menu.6 Select the ‘Time out’ with the or button.7 Press ‘next/select’ to enter the ‘Time out’ menu.8 Select the desired time out with the or button.9 Press ‘next/select’ to confirm the selected time-out.10 Press ‘on line’ to put the printer on line again.
