Printing (Netware)22-106 VL6522c/VL5522c/VL4522c2.32In Remote Printer mode using the NetWare 4.x Bindery Emulation0 When you use the Bindery Emulation, make sure that the Bindery Emulation has been enabled on theNetWare server.1 From the client, log in the NetWare file system as Bindery with the administrator authority.2 Start Pconsole.3 Select "Quick Setup" from "Available Options" list box, and press the [Enter] key.4 Fill in "Print Server Name", "Printer Name", and "Print Queue Name". Set the "Type" of the printer to"Other/Unknown", and save them.5 Terminate Pconsole by pressing the [Esc] key.6 Load the PSERVER.NLM file on the NetWare Server console.Then, configure the following settings in "NetWare Setting".In Print Server mode using the NetWare 4.x Bindery Emulation0 When you use the Bindery Emulation, make sure that the Bindery Emulation has been enabled on theNetWare server.0 When you select the Print Server mode, the IPX protocol must already be loaded on the NetWare server.1 From the client, log in the NetWare file system as Bindery with the administrator authority.2 Start Pconsole.3 Select "Quick Setup" from "Available Options" list box, and press the [Enter] key.4 Fill in "Print Server Name", "Printer Name", and "Print Queue Name". Set the "Type" of the printer to"Other/Unknown", and save them.5 Terminate Pconsole by pressing the [Esc] key.Then, configure the following settings in "NetWare Setting".Item Description Prior checkIPX Setting Select "ON".Ethernet FrameTypeSelect a frame type to be used. Frame typeNetWare PrintModeSelect "Nprinter/Rprinter".Print Server Name Enter a print server name to be operated as the Nprint-er/Rprinter (up to 63 characters, excluding / \ :; , * [ ] < > |+ = ? .).The print servername specified inStep 4Printer Number Enter the Nprinter/Rprinter number.