Check the status of the toner reservoirsIntroductionThe machine has 2 toner reservoirs. The toner reservoirs are located at the left-hand sideand the right-hand side of the engine module ‘Introduction to the main system components’on page 26. You can check the status of the toner reservoirs in the dashboard ‘The dash-board’ on page 40 and in the 'System' view. The 'System' view also displays the currentfilling level of each toner reservoir as a percentage. The icons in the following table indicatethe status of the toner reservoirs.This section gives an overview of the possible toner statuses. Furthermore, this sectiondescribes how to check the status.The meaning of the toner iconsThe toner icons#DescriptionToner iconThe toner icon is blue. All 3 blocks of the status bar are green.The toner reservoir is filled over 75%. Do not add toner.The toner icon is blue. 2 Blocks of the status bar are green. Thetoner reservoir is filled over 50%. You can add 1 bottle of toner.The toner icon is blue. 1 Block of the status bar is green. Thetoner reservoir is filled over 25%. You can add 2 bottles oftoner.The toner icon is orange. The status bar contains no more greenblocks. The toner reservoir is filled less than 25%. The printercan print another 600 sheets. You must add up to 3 toner bottlesas soon as possible.The toner icon is red. The status bar has a red frame. The tonerreservoir is empty. The printing stops. You must add maximum3 toner bottles to continue the printing.The toner icon is grayed out. The status of the toner reservoiris unknown. This status is only displayed when the system isinitializing.The toner icon is grayed out and has a blue dotted frame. Thestatus bar is grayed out and has a red dotted frame. The statusof the toner reservoir is unknown. This status is only displayedwhen the toner access cover is open.Chapter 5 - Working with the operator panel 109Check the status of the toner reservoirs