Instructions for printing to the stacker/stapler (iMFS)IntroductionNote:This section only applies to the use of oriented media and tab sheets in combinationwith the optional stacker/stapler (iMFS).The machine supports oriented media. Oriented media are media of which the front sidediffers from the back side. An example of oriented media is media with a company logo.If you use oriented media and print to the optional stacker/stapler, you must place themedia into the paper trays as follows:• Face up and header down (for long-edge feed)The face of the media, for example a company logo, is visible and point towards thefront of the printer.• Face up and header to the left (for short-edge feed).The face of the media is visible and points towards the left-hand side of the printer.This orientation makes sure that the documents are stapled at the correct position.Special instructions for the use of oriented mediaWhen a job contains oriented media but no tab sheets, you must put this media headerdown into the paper tray. The media must align with the header-down orientation of theprinted images (header down for long-edge feed and header to the right for short-edgefeed).Special instructions for the use of tab sheetsWhen a job contains tab sheets, you must do the following.• Put all the oriented media for the job, including the tab sheets, header up and headerto the left (for short-edge feed) into the paper tray.• Temporarily change the default media orientation on the Controller to 'Header-up'.To do this, you must go to the setting 'Preferences' - 'Print job defaults' - 'Stacker/sta-pler (iMFS)' or 'Stacker/stapler upper output' - 'Header orientation'. There you canclick the radio button for 'Header-up'.Jobs that contain tab sheets are sent to the stacker/stapler when no stacker is present.When a stacker is present, the jobs are sent to the stacker to improve the stack quality.Chapter 5 - Working with the operator panel 51Instructions for printing to the stacker/stapler (iMFS)