Specifying settings from the control panel 3cm3521 3-115Specifying settings from the control panel Chapter 33.27 SLP settingsThe use of SLP can be enabled or disabled. If set to “Enable”, devices canbe searched using TWAIN. If set to “Disable”, device cannot be searched.To specify SLP settings1 In the Administrator Setting screen, touch [5 Network Setting]. (Refer topage 3-8 for more details.)2 In the Network Setting screen, touch [9 Detail Setting].3 In the Detail Setting screen, touch [6 SLP Setting].The SLP Setting screen appears.4 Touch [Enable] or [Disable].5 Touch [OK].The use of SLP is enabled or disabled.2 NoteTo cancel changes to the setting, touch [Cancel].To quit specifying the Utility mode setting, touch [Exit] in the sub displayarea. Otherwise, cancel the Utility mode by touching [Close] in eachscreen until the screen for the Copy, Fax, Scan or Box mode appears.
