2-2LOADING PAPERIf the paper runs out during printing, a message will appear in the display.Follow the procedure below to load paper.Loading paper in paper tray 11 Pull out paper tray 1.Gently pull the tray outuntil it stops.2 Load paper into the tray.Do not load paper abovethe maximum height line(approximately 500sheets of 20 lbs. (80g/m 2) paper).3 Gently push tray 1 into the machine.Push the tray firmly all the way into the machine.4 Set the paper type.If you change the paper type setting if the papertype is changed in either paper tray, refer to"Setting the paper type and paper size" (page 2-5 ).5 Loading paper in paper tray 1 is nowcomplete.Changing the paper size in paper tray 1For paper tray 1, 8-1/2" x 11", A4 or B5 size paper can be set. Use the following procedure to change the size asneeded.1 Pull out paper tray 1.If paper remains in the tray, remove it.2 Adjust the guide plates A and B in the trayto the length and width of the paper.The guide plates A andB are slidable. Adjustthem to the paper size tobe loaded whilesqueezing their locklevers.3 Load paper into the tray.4 Gently push tray 1 into the machine.Push the tray firmly all the way into the machine.5 Set the paper size.Be sure to set the paper size and paper typereferring to "Setting the paper type and paper size"(page 2-5).If this is not done, paper misfeeds will occur.6 Changing paper size in paper tray 1 is nowcomplete.NOTES● Do not use curled or folded paper. Doing so may cause a misfeed.● For best results use paper supplied by Océ. (See page 2-4.)● When you change the paper type and size in paper tray 1, set the paper type and size referring to "Setting thepaper type and paper size" (page 2-5 ).● Do not place heavy objects or press hard on any tray which is pulled out.● Load paper with the print side face up. However, when the paper type is set to "PRE-PRINTED","PRE-PUNCHED" or "LETTER HEAD", load the paper face down*.* If the two-sided function is disabled using "DISABLING OF DUPLEX" in the administrator settings (page 11of the administrator settings guide), load the paper face up.
