Oki B721 User Manual

Also see for B721: User manual User manual

Contents

Oki B721 User Manual Manual pdf 130 page image

- 130 -Other Operations4 4. Network Settings8 Click [Start] and select[Administrative Tools]>[DHCP] tolaunch the [DHCP] wizard.9 On the DHCP list, select a server to use.10 From the [Action] menu, select [NewScope].11 On the [New Scope Wizard], follow theon-screen instructions and configure thesettings as necessary.Memo● Be sure to configure the default gateway settings.● On the [Activate Scope] screen, select [Yes, Iwant to activate the scope now].12 Click [Finish].13 Select the new scope from the DHCP listand then select [Reservations].14 From the [Action] menu, select [NewReservation].15 Configure the settings.16 Click [Add].17 Click [Close].18 From the [File] menu, select [Exit].Configuring Your PrinterThe following explains how to configure yourprinter to use DHCP/BOOTP.Note that since the DHCP/BOOTP protocol isenabled by factory default, you do not have toperform this procedure.Memo● The following steps are explained using Network CardSetup as an example. The steps and menus may differdepending on the software you use.1 Turn on the printer.2 Turn on your computer and insert thesoftware DVD-ROM.3 Click [Run Setup.exe].If the [User Account Control] dialog boxappears, click [Yes].4 Read the license agreement and click[Agree].5 Read the [Environmental advice forUsers] and then click [Next].6 Select a device to be used and then click[Next].7 Select [Network connection] and theclick [Next].8 Click [Device Network Setup].9 Select your printer from the list and click[Next].10 Enter the IP address and then click[Setup].11 Enter the password at [Password] andthen click [OK].- The factory default password is the last sixdigits of the MAC address.- The password is case-sensitive.The network card reboots to enable the newsettings.12 Click on [Exit].