- 17 -Preparing Your Printer1 1. Setup●● Preparing Your PrinterThis section explains how to unpack your printer and how to turn it on and off.UnpackingCAUTION It may cause injury!● At least two people are needed to lift the printersafely because it weighs about 37 Kg or 40 Kg.Note● Be sure to use the consumables or maintenance unitsprovided with this printer at first. Otherwise, the life of theconsumables or maintenance units may not be displayedcorrectly, or you may not be able to use them later.● The image drum (the green tube) is very delicate. Handleit carefully.● Do not expose the image drum to direct sunlight or verybright interior light (approximately more than 1500 lux).Even under the normal interior light, do not leave it formore than 5 minutes.● Packaging and cushioning material are needed iftransporting the printer. Do not throw them away.1 Remove your printer from the box andremove all cushioning materials and theplastic bag from your printer.2 Remove the two strips of protective tape(1) at the back of your printer.1Installing Consumables1 Insert your finger into the recess onthe right side of the printer and pull thefront cover open lever (1) to open thefront cover (2) forward.Note● Open the front cover gently. If opening rapidly, an MPtray may open.122 Press the top cover open button (3) andopen the top cover (4).343 Take out all four image drums from theprinter.
