Oki C834DN User Manual

Also see for C831dn: Safety and Warranty Guide User manual User manual

Contents

Oki C834DN User Manual Manual pdf 21 page image

- 21 -Preparing Your Printer1 1. SetupTurning On/Off the PowerPower Supply ConditionsThe power supply must meet the followingconditions:Current: 110 - 127 VAC (Range 99 - 140 VAC)220 - 240 VAC (Range 198 - 264 VAC)Frequency: 50/60 Hz ± 2%Note● If the power supply is unstable, use a voltage regulator.● The maximum power consumption of this printer is1400 W. Ensure that the power supply is sufficient tooperate this printer.● We do not guarantee operation where an uninterruptiblepower system (UPS) or inverter is used. Do not use anuninterruptible power system (UPS) or inverter.WARNINGThere is a risk of gettingan electric shock and/orcausing fire.● Be sure to turn off the power supply switch whenattaching or removing the AC cable and earth wire.● Be sure to connect an earth wire to the groundingterminal of exclusive use.● Please do not connect with the ground of a water pipe,a gas pipe, and a telephone wire, and a lightning rod byany means.● Make sure to connect with the ground terminal beforeconnecting the power cord to the power supply plug.● Be sure to plug in and unplug the AC cable while holdingon to the power supply plug.● Insert the AC cable plug completely into the wall socketsecurely.● Do not touch the power cord, or printer, if your handsare wet.● Install a power cord in the place which is not steppedon, and do not place a thing on a power cord.● Do not use the cord tied in a bundle.● Please do not use the damaged power cord.● Do not use multi-outlet adapters.● Do not connect this printer and other electric productsto the same wall socket. If it connects simultaneouslywith an air conditioner, copier, shredder, etc. Especially,a printer may incorrect-operate by the electricnoise. When you connect with the same wall socketunavoidably, please use a commercial noise filter or acommercial noise cut transformer.● Use the attached power cord and insert it directory withthe ground terminal. Do not use the power cord forother product for the printer.● Do not use an extension cord. When you use itunavoidably, use the thing more than rated 15 A.● Use of an extended code may not operate a printernormally by AC voltage descent.● During printing, do not shut off a power supply or do notpull out a power supply plug.● When you use it neither for consecutive holidays nor atravel for a long time, pull out a power cord.● Do not use attached power cord to the other products.Turning On the Power1 Plug the AC cord (1) into the AC powersocket of your printer.12 Plug the AC cord into the electric socket.3 Hold down the power switch (2) forabout a second to turn on the power.2The message “Ready To Print” is displayed inthe operator panel.