8.WHEN SOMETHING IS WRONG WITH THE EQUIPMENTWhen You Think Something Is Wrong With the Equipment 1198 WHEN SOMETHING IS WRONG WITH THE EQUIPMENT Originals and paperProblem Description Cause Corrective ActionThe original is misfed. The original is unsuited for theequipment.Check whether the original is suitable for the equipment.For details, refer to Chapter 2 of the Copying Guide.Paper is misfed. The paper is unsuited for theequipment.Check whether the paper is suitable for the equipment.For details, refer to Chapter 1 of the Copying Guide.The paper size setting registered forthe equipment is inconsistent withpaper in a tray or on the MPT.Match the size of the paper placed in the tray or on theMPT and the size registered on the equipment.For details, refer to Chapter 1 and 2 of the CopyingGuide.The stack of paper exceeds theloading line indicated on the sideguide.Remove some paper to set it within the height limit lineindicated on the side guide.There is too little or too muchclearance between the paper and theside guide of the tray.Adjust the space between the paper and the side guide orthe end guide not to take much space.For details, refer to Chapter 1 of the Copying Guide.Hidden misfed paper has not beenremoved.Check the sign again on the touch panel to see where themisfeed occurred.P.14 “Clearing a Paper Misfeed”Two or more sheets of paper arefed together.Sheets of paper are stuck together. Loosen the stack of paper well and set it again.Sheets are not aligned whenexiting.Sheets are placed in the tray with thewrong side up.Check the printing side of the sheets and place themcorrectly. Information about the printing side may be givenon the wrapping paper of the sheets.If you cannot find which side is the printing side, tryprinting on both sides to see if the sheets are alignedwhen exiting.The message indicating no paperdoes not disappear even afterpaper is placed in the tray.Sheets placed in the tray are notaligned.Remove the sheets from the tray, align them, and replacethem.The side and end guides do notmatch the paper size in the tray.Adjust the side and end guides to match the paper size.The amount of paper placed in theLarge Capacity Feeder is too small.Place more than 10 sheets of paper in the Large CapacityFeeder.