1 TROUBLESHOOTING FOR THE HARDWAREWhen Printed Sheets Overflow from the Stacker 69When Printed Sheets Overflow from the StackerWhen thin, small size paper (A4-R/LT-R or smaller) is used, the end of the sheets may get stuck in the stacker walls. If 300or more sheets are printed under such condition, some printed sheets may be pushed out of the stacker.In the case above, installing the paper exit stopper at the designated location of the stacker will increase the amount ofrecommended plain paper that can be loaded on to the stacker to about 500 sheets.y When printing a large number of large size sheets such as A3 and A4/LD and LG, place the paper exit stopper backin its original location.y When the finisher or inner finisher is installed in the equipment, use the paper exit stopper installed in its originallocation.Removing the paper exit stopper from its original locationInstalling the paper exit stopper in the designated location for improving paper exitPlacing the paper exit stopper back in its original location1 Remove the paper exit stopper from the groove on the stacker while pushing itsfulcrum inward.1 Unfold the paper exit stopper located on the left of thestacker and remove it from its groove while pushingthe fulcrum inward.1 Turn the tip of the paper exit stopper to the left andinsert the paper exit stopper fulcrum into the grooveon the stacker.2 Install the paper exit stopper in the groove on the leftof the stacker.
