Disassembly 4 - 7 OKIFAX 5300/5600Service Manual, P/N 592783014.2.3.1 LED Print Head(1) Disassembly procedurea) Open the Document Tableassembly.b) Open the Stacker Cover bypushing the Buttons.c) Disconnect the PC connectorfrom the LED print head.d) Disconnect the flat cable fromthe PC connector.e) Remove the LED print headwhile spreading the retainer onthe Stacker Cover.Note:Be sure not to touch directly or push the SLApart of the LED print head.(2) Reassembly procedureReverse the disassembly procedures.Note:After replacing the LED print head, setdrive time of the LED print head follow-ing the marking. (Refer to section 5.1).When you replace the LED print head,if the width of the LED head to be usedis changed from current version, youshould select the head width by theservice personnel initial setting (No.28). (Refer to table 2.9.1 TF No. 28)(FX-050VP-C4-001)Document GuideStacker CoverButtons(FX-050VP-C4-002)Flat cablePC connectorSLA partRetainerLED print headStacker CoverTwo kinds of LED print heads are available.208 mm (8.19 inches) width or216 mm (8.50 inches) width
