845 Press the mode button to light up the MCRlamp and then hold the button down (for 2or more seconds).The PC lamp now lights, and PC mode isestablished.When the P2 card is in an accessible status,USB (or 1394) DEVICE CONNECT is displayedon the camera.(If DISCONNECT is displayed, you cannotoperate the camera.)6 Proceed with nonlinear editing using yourcomputer.An icon for the P2 card contents appears asa removable disk in My Computer of yourcomputer.• For further details, refer to the instructions foryour computer’s editing software.• When replacing one card with another, ifthe USB connection is used, check that theaccess lamp is not flashing and that the dataon the card is not being accessed beforeejecting the card. If the 1394 connection isused, place the drive icon into the computer’srecycle bin before ejecting the card.• The unit cannot be operated while in PCmode.• When the cable is to be disconnected,proceed with “Safely Remove Hardware” onthe computer.In the case of a 1394 connection, firstconfirm that “1394 DEVICE DISCONNECT”is displayed on the camera-recorder beforedisconnecting the cable. In the case of a USBconnection, “USB DEVICE CONNECT” willremain displayed so check that the card isnot being accessed before disconnecting thecable.7 Switch OFF the camera.You cannot cancel the PC mode even ifyou press the operation mode button for anextended period.P2 cards are compliant with the Type-IIstandard so you can insert them straight intothe computer’s card slots and proceed withnonlinear editing.• The Card Bus driver is contained in the CD-ROMprovided.P2Nonlinear editing with P2 card (PC mode) (continued)
