116Using a hard disk drive (PC mode: USB host) (continued)Writing data back to P2 cardsSelecting clips on the hard disk driveYou can select clips on the hard disk drive to bewritten back to P2 cards.1 Switch the mode to USB HOST.• “Switching to the USB HOST mode” (Page 111)• The thumbnail screen is displayed.(USB HOST is displayed in the bottom right.)2 Connect a hard disk drive via USB.3 Insert the target P2 card in a slot.4 Press the MENU button and select HDD →EXPLORE from the thumbnail menu. Moveto the appropriate partition and select itwith the SET button on the Operation lever.5 From among the thumbnails, select theclips to be written to the P2 card.6 Press the MENU button and selectOPERATION → COPY. Then, specify theslot that contains the target P2 card.7 Select YES.• This starts the data write to the P2 card.• When the writing is completed, the message“COPY COMPLETED!” is displayed.• When only selected files are written, noverification is performed.• Copy data in clip units from cards with adifferent model number as data cannot beimported by the partition between suchcards. Copy data by clip.Selecting clips from the thumbnailmenuFor a Type-S or P2 STORE hard disk drive, youcan write data back to a P2 card with the samemodel number on a card basis. The target P2 cardsmust be preformatted.1 Switch the mode to USB HOST.• “Switching to the USB HOST mode” (Page 111)• The thumbnail screen is displayed.(USB HOST is displayed in the bottom right.)2 Connect a hard disk drive via USB.3 Insert the target P2 cards in slots.4 Press the MENU button and select HDD →EXPLORE from the thumbnail menu. Moveto the appropriate partition and select itwith the SET button on the Operation lever.5 From the thumbnail menu, selectOPERATION → IMPORT. Then, specifythe slots that contain the empty target P2cards.6 Select YES.• This starts the write process.• When the writing is completed, the message“COPY COMPLETED!” is displayed.To disable verification during writing, selectHDD → SETUP from the thumbnail menu andset the option VERIFY to OFF. This speeds upwriting without verifying data writing.• If a clip is written back to a P2 card differentfrom the original card that contained thatclip, then the clip may be incomplete. If thisis the case, reconnect the clip.• “Reconnection of incomplete clips” (Page 85)• Copy data in clip units from cards with adifferent model number as data cannot beimported by the partition between suchcards. Copy data by clip.
