– 11 –Controls and their functionsQQQQQ PREROLL buttonThis is used for feeding and cueing the tape for manual editing.When it is pressed, the tape travels to the preroll point where it stops.The preroll time can be set on the setup menu No. 000 (P-ROLL TIME).When this button is pressed together with the IN or OUT button, the tape can be cued tothe IN or OUT point entered.When the AUTO ENTRY on the setup menu No. 305 is set to “ENA”, IN point has beenentered at the point where the PREROLL button is pressed even if the IN point has notbeen entered.RRRRR AUTO EDIT buttonAutomatic editing is executed when this is pressed after an edit point has been entered.When the AUTO EDIT button is pressed though the IN point has not been entered,automatic editing is executed using the point at which the button was pressed as the INpoint.SSSSS PREVIEW/REVIEW buttonsPREVIEW: When this is pressed after an edit point has been entered, the tape travels,editing is not performed, and the preview can be activated on the screenconnected to the recorder.If it is pressed when the IN point has not been entered, the point at which thebutton was pressed is entered as the IN point, and preview is executedaccordingly.REVIEW: If this is pressed after a block has been edited, the now edited block can beplayed back and monitored on the screen connected to the recorder.TTTTT IN (A IN)/SET/OUT (A OUT) buttonsWhen IN (A IN) or OUT (A OUT) button is pressed together with the SET button, the IN (AIN) or OUT (A OUT) point is entered.A IN and A OUT are used during audio split editing to enter an audio IN or OUT point thatdiffers from the video In or OUT point.While an IN (A IN) or OUT (A OUT) point is selected, the IN (A IN) or OUT (A OUT) buttoncorresponding to the point entered lights. When this button is pressed after a point hasbeen entered, the IN (A IN) /OUT (A OUT) point value appears on the counter display.When the IN (A IN) or OUT (A OUT) button is pressed together with the RESET button, theIN (A IN) or OUT (A OUT) point is cleared.UUUUU TRIM buttonsThese buttons are used to trim IN or OUT point finely.When the “+” or “–” button is pressed while the IN or OUT button is held down, the enterededit point can be trimmed in 1-frame increments. When the “+” button is pressed, the tapeis advanced by one frame; when the “–” button is pressed, it is rewound by one frame.VVVVV ASMBL buttonThis is pressed for assemble editing.The button is self-illuminating, and it is set ON (lamp lights) when it is pressed once andOFF (lamp goes off) when it is pressed again.WWWWW INSERT buttonsPress one of these seven buttons to select the input signals to be edited during insertediting.The buttons are self-illuminating, and they are set ON (lamp lights) when they are pressedonce and OFF (lamp goes off) when they are pressed again.The audio channels (CH1 to CH8) are allocated to CH1-4 or CH5-8 using the AUDIO CHSELECT button Z.
