106 Editing: Setting Audio LevelWhen registering a new event in a playlist, change the audiolevel during the registration of the event.1 Assign IN and OUT points to enable eventregistration.2 Use the UNITY/VAR channel selection switch toselect tracks for level setting.3 Press the PREVIEW button to register the event.During preview, the audio is output according to the setlevel.4 Use the UNITY/VAR channel selection switch of theaudio fader and fader control during previewplayback to change the level.After ending or interrupting a preview, the audio level setso far is reflected and an icon indicating that a level settinghas been made appears on the event on the timeline.5 Check audio level by performing a review or playlistplayback.◆ NOTE:• If the level setting value for all sections in an event is UNITY, the iconindicating that an event level setting has been made does notappear.• If a level setting for an entire playlist has been made for an extendedperiod of time, a level setting cannot be added and an error isdisplayed.• A level setting for the preroll and postroll playback section cannotbe changed.• This method for setting the audio level is not available when theplayer is a hard disk or an external device.When an event has been captured to a P2 card, set the audio level.• Repeating previewing clears the level setting for the preview sectionwhere track selection is available at the start of each preview.• When a preview is interrupted during the preroll section, the levelsetting is not made and the previous level setting is not cleared.• Pressing the STOP button to interrupt preview makes settings validuntil stopping. Audio level after the interruption point in the event isset to the same level as the interruption point.Use the following steps to change the audio level for specificsections in a playlist.1 Press the PLAYER button to switch to recorderoperations.2 Set the IN point at the location where you want tostart setting the audio level of the recorder and setthe OUT point where you want it to end.➝Refer to “Setting IN and OUT points” (page 91).3 Select the track where the audio level will be set.Select using the A1/A2/A3 (SHIFT + A1)/A4 (SHIFT + A2)buttons.4 Press the A LEVEL REC (SHIFT + PREVIEW) buttonto start audio level recording/playback.Playback starts at the beginning of the preroll time sectionbefore the set IN point and stops 1 second later. Duringplayback of audio level recording, the recorder screendisplays "A LEVEL REC".Changing Audio Level in an Eventduring Event RegistrationCLIPF3 SHIFTPF4TOUTUBDETCGTC PRESETPROPRESETCOUNTERPLAYER STOPSTILL/PAUSEPREVIEWA.LEVEL RECREWRECFFPREV NEXTPLAYREVIEW1 CLIP PLAYSOURCE SELECTNEWTREGENRESETEXTMODECONTROLREMOTELOCALUNITY422 4UNITY311 3PBCH3010010202/4CH1/32,445 3Setting Audio Levels for SpecificSectionsIN ENTRYSLOT CLIPPF1 ALL CLIPPF3 SHIFTPF4CLIP LISTPF2SLOT SELECTLAST X TRIMDELETEVIDEO GO TOOUTEDIT MODE A.DUBMODEA1A3A2A4CH 3 CH 4 TEXTMEMO TCGTC PRESETPROPRESETCOUNTERPLAYER STOPSTILL/PAUSEPREVIEWA.LEVEL RECREWRECFFPREV NEXTPLAYREVIEW1 CLIP PLAYSOURCE SELECTNEWINTREGENPRESETEXTMARKERMODECONTROLREMOTELOCALUNITY422 4UNITY311 3PBCH3010010202/4CH1/3463 51
