150 AVCHD Recording and Playback: Using an Optional AVCHD BoardUSER CLIP NAME to be recorded• When clip metadata is loaded• When clip metadata is not loaded or when loaded clipmetadata is not to be recorded*1:The counter value is indicated as a four-digit number.The counter value is incremented by 1 each time a clip isplayed back when clip metadata is loaded and recordingmethod TYPE2 is set for recording metadata.Use the following procedure to reset the counter value.Press the MENU button, choose [META DATA] – [CLIPCOUNT RESET] – [YES] and press the SET button to resetthe counter value to 1.Adding shot marks (M) makes it easier to find desired clip.1 Press the cursor buttons to move the yellow frame tothe clip to which you will add a shot mark.2 Press the MARKER (SHIFT + TEXT MEMO) button.To cancel a shot mark, repeat the above operation.Set playback format and playback type.Use the steps below to set playback format.➝Refer to “Menu Operations” (page 34).1 Press the MENU button.2 Select [PLAY SETUP] and press the SET button.3 Select [PB FORMAT] and press the SET button.4 Press the up and down (4/5) cursor buttons to selectplayback format and press the SET button.• Available formats(When SYSTEM FREQ is set to 59.94 Hz)1080/60i(30P), 1080/24P, 720/60P(30P), 720/24P(When SYSTEM FREQ is set to 50 Hz)1080/50i(25P), 720/50P(25P)5 Press the MENU button to return to the thumbnailscreen.Clips with black numbers can be played while clips withred numbers cannot be played back.Switching to the normal mode will replace a set playbackformat with a playback format set by the setup menuNo. 020 (SYS FORMAT).When setup menu No. 160 (REPEAT PLAY) is set to ON, allplayable clips will be played continuously.➝Refer to “Setup” (page 155).Resume play starts playback from where it was lastinterrupted.1 Press the MENU button.2 Select [PLAY SETUP] and press the SET button.3 Select [RESUME PLAY] and press the SET button.4 Select [ON] and press the SET button.5 Press the MENU button to return to the thumbnailscreen.6 Select clip to play back.When playback is interrupted, the resume play indicatorappears on the clip thumbnail and playback continuesfrom this point the next time playback is started.TYPE1: Loaded dataTYPE2: Loaded data + counter value*1TYPE1: A 5-digit serial number assigned inshooting orderTYPE2: A 5-digit serial number assigned inshooting orderAdding shot marks to clipsSetting up for PlaybackSetting playback format (PB FORMAT)Repeat playback (REPEAT PLAY)Resume playback (RESUME PLAY)
