Editing: Playlist Function 75EditingPlaylist mode uses a player and a recorder to create a playlistthat stores editing results.The player thumbnails or playback video appear on the leftside of the playlist screen.Normally, clips on a P2 card are used, but clips from a harddisk, VTR or other device connected and controlled via theREMOTE connector (RS-422A) can also be used.➝Refer to “Names and Functions of the Playlist Screen” (page77).The recorder playback video appears on the right side of theplaylist screen and the timeline is shown below. The recorderallows you to check playback and editing results.➝Refer to “Names and Functions of the Playlist Screen” (page77).The following walks you through the steps to perform cutediting.1 Determine the format for the clip playlist you want toedit in the setup menu.➝Refer to “Preparing for Playlist Creation” (page 86).2 Press the PLAY LIST button to open the playlistscreen.3 Press the NEW (SHIFT + RESET) button to clearplaylists stored in the unit.4 Press the EDIT MODE (SHIFT + VIDEO) button toselect overwrite editing and select all tracks.5 Press the PLAYER button to switch to player (leftside) operations.The PLAYER button goes on during player operation.6 Start player playback, set the IN point (IN + ENTRYbutton) and OUT point (OUT + ENTRY button) tospecify the section of the clip you need.7 Press the PLAYER button to switch to recorder (rightside) operations.The PLAYER button goes out.8 To add a cut when there are events in the recorder,start playback and set an IN point by pressing the IN+ ENTRY button.After the playlist has been cleared in step 3, an IN point isautomatically set at the beginning of the recorder.9 Press the PREVIEW button to preview and checkediting results.In the preview, the edited section is added to the timeline.10Repeat steps 5 to 9 to connect cut sections.11Finally, use the cursor buttons to move the cursorto the beginning of the event and start playback onthe recorder.The playlist is played back.Use Edit Copy ([OPERATION] - [EDITCOPY] menu) asrequired to create a new clip from the created playlist.Editing WorkflowPlayerRecorderCut editing workflowOFFMETERFULL/FINEMONITORSELECTMETER SELECTINPUT SELECTRECTHUMBNAILSETMENU IN ENTRYSLOT CLIPPF1 ALL CLIPPF3 SHIFTPF4CLIP LISTPF2SLOT SELECTLAST X TRIMDELETEVIDEO GO TOOUTEDIT MODE A.DUBMODEA1A3A2A4DIAGOPERATIONEXITCANCEL/PFMULTISELCH 1 CH 2 CH 3 CH 4 TEXTMEMO TCGTC PRESETPROPRESETCOUNTERPLAYER STOPSTILL/PAUSEPREVIEWA.LEVEL RECREWRECFFPREV NEXTPLAYREVIEW1 CLIP PLAYSOURCE SELECTNEWINTREGENPRESETEXTMARKERVARUNITYVIDEO AUDIOCH 1-4 CH 5-8PLAYLIST3 92 5,741,11 6,8
