233Chapter 3 Recording and Playback (continued)Removing P2 Cards1 While pressing down the slide lock button, move theslide-out door to the left.The door opens.2 Tilt down the EJECT button.3 Then, depress the EJECT button to release the P2 cardso that you can remove it.z When a P2 card is being accessed or it is beingrecognised after insertion (P2 CARD ACCESS LED blinksin orange), do not remove the P2 card.If your AJ-SPC700E is not set to turn on the P2 CARDACCESS LED, before removing the card ensure that pre-recording and/or voice memo recording have finished (theP-REC indication has stopped blinking and the V mark orVOICE REC indication on the viewfinder screen hasturned off) after stopping recording or playback.z If a P2 card being accessed is removed, the viewfinderdisplays “TURN POWER OFF” and the AJ-SPC700Egives a warning using an alarm and the WARNING LED.In addition, all P2 CARD ACCESS LEDs blink rapidly ingreen. If this is the case, turn the power off. For moreinformation on warning indications, see [7-3 WarningSystem].z If a P2 card is removed while being accessed, clips on itmay become irregular although the data will not becorrupted. Check the clips and restore them if required.For more information about how to restore clips, see [6-9Restoring Clips].z If a P2 card being formatted is removed, it may be not beformatted properly. In this case, the viewfinder displays“TURN POWER OFF”. If this message appears, turn offthe power, then restart the AJ-SPC700E to reformat thecard.z If a P2 card is inserted while another P2 card is beingplayed back, the inserted P2 card is not recognised andthe P2 CARD ACCESS LED for that card does not comeon. Card recognition starts when the playback ends.The P2 CARD ACCESS LEDs may be set to stay off usingthe menu option ACCESS LED. This option can be found onthe screen, which is accessible from theSYSTEM SETTING page.To Prevent Accidental Erasure of P2 Card ContentTo prevent the content of a P2 card being accidentallyerased, position the write-protect switch on the P2 card at[Protect].Write-protect switchover can be performed while the card isbeing accessed (during recording or playback), but does nottake effect until access to the card ceases.* The mode check indication is shown in the viewfinder. For moreinformation, see [4-7-2 Viewfinder Status Indication Layout].Depress the tilted-downEJECT button to releasethe P2 card.Tilt down the EJECTbutton.P2 CARD ACCESS LED and status of P2 cardsP2 CARDACCESS LEDMODE CHECKindication* Status of P2 CardStays on in green ACTIVE Writing and readingenabledStays on inorange ACTIVEWriting and readingenabled. The card isrecordable (loop recordingalso enabled).Stays on inorange or green ACTIVE !Writing and readingenabled. However, someclips recorded on the P2card may not be able to beread successfully.Blinks in orange ACCESSING Writing or reading beingperformed.Quickly blinks ingreen INFO READING The P2 card is beingrecognised.Blinks in greenFULLThe P2 card has no freespace. Only reading isenabled.PROTECTEDThe write-protect switch onthe P2 card is positioned at[PROTECT]. Only readingis enabled.Stays offNOTSUPPORTEDThe card is not supportedby your AJ-SPC700E.Replace the card.FORMAT ERRORThe P2 card is not properlyformatted. Reformat thecard.NO CARD No P2 card is inserted.ProtectWrite-protect switchᤨࠫ
