Panasonic AW-RP50E Operating Instructions Manual

Also see for AW-RP50E: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

17 (R)Network settingsSetting the IP addressOn the [SYSTEM] menu, select the [NETWORK] menu, anddisplay [IP ADDRESS].Then operate the F2 dial to set the IP address.Select a setting which will not duplicate the IP setting ofanother device.1.IP ADDRESS ▼192 168.000.009If the same IP address is used more than once, the “IPDuplication!” message is displayed on the LCD panel.1.IP ADDRESS ▼IP Duplication!If the IP address is incorrect, the following message isdisplayed on the LCD panel.Unavailablenetwork setting In order for the setting to take effect, the unit must berestarted.Turn off the unit’s power, and then turn it back onagain. Consult the network administrator before setting theIP address.NotesSetting the subnet maskOn the [SYSTEM] menu, select the [NETWORK] menu, anddisplay [SUBNETMASK].Then operate the F2 dial to set the subnet mask.2.SUBNETMASK255 255.255.000If the subnet mask is incorrect, the following message isdisplayed on the LCD panel.Unavailablenetwork settingIn order for the setting to take effect, the unit must berestarted.Turn off the unit’s power, and then turn it back on again.NoteSetting the default gatewayOn the [SYSTEM] menu, select the [NETWORK] menu, anddisplay [GATEWAY].Then operate the F2 dial to set the gateway.3.GATEWAY192 168.000.001If the default gateway is incorrect, the following message isdisplayed on the LCD panel.Unavailablenetwork settingIn order for the setting to take effect, the unit must berestarted.Turn off the unit’s power, and then turn it back on again.NoteSetting the port numberSet the port number for the remote camera.On the [SYSTEM] menu, select [CAM PORT] and display[PORT:CAM1] to [PORT:CAM100], and then operate the F2dial to set the port number.1.PORT:CAM1 ▼80Setting the MAC addressOn the [SYSTEM] menu, select the [NETWORK] menu, anddisplay [MAC ADDRESS].4.MAC ADDRESS ▲