Panasonic AW-RP50E Operating Instructions Manual

Also see for AW-RP50E: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

30 (E)ENGLISHSelecting the remote cameras to be operatedUp to five remote cameras to be operated can be selectedusing the CAMERA STATUS/SELECTION buttons.When one of the CAMERA STATUS/SELECTION buttons1 to 5 is pressed, the indicator of the corresponding buttonlights.The statuses of the remote cameras assigned to CAMERASTATUS/SELECTION buttons 1 to 5 can be identified by thelighting statuses of the indicators above the buttons.R/B GAIN R/B PEDSYSTEMSETUPCAMERASCENE/MODEDETAILDELETESTOREPAGEMENU F2 EXITUSER2USER1PT ACTIVEAUTOIRIS CAMERA STATUS / SELECTIONPRESET MEMORY / MENUGAIN/PED1 2 3AWB/ABB4SHUTTER51 2 3 4 56 7 8 9 10Indicator lighting statuses and remote camera statusesIndicatorlighting status Remote camera status The unit and remote cameraconnectionsOFF No remote camera has been assigned to the corresponding button.(“NoAsign” is set for the remote camera connection.) The power of the remote camera has not been turned on.IP connection/Serial connectionON(orange)The remote camera is in the standby status. IP connection/Serial connectionBlinking(orange)Five other controllers are connected to the remote camera so even when the remotecamera has been selected from the unit the selection is rejected. IP connectionON(green)The unit is now connected with the remote camera. IP connection/Serial connectionBlinking(green)Another device (AW-RP50) has selected the corresponding remote camera. IP connectionON(red)The image of the corresponding remote camera is now on the air.(The OA tally signal is received over the network or at the GPI input connector.) IP connection/Serial connectionBlinking(red)Another device (AW-RP50) has selected the corresponding remote camera, and theimage of the remote camera is now on the air. IP connectionUp to 100 cameras can be divided into 1 to 20 groups bymenu operations, and controlled by the unit.The selection procedure is described below.1 Set the MENU button to ON.Press the MENU button and light its indicator.2 Set the PRESET MEMORY/MENU 8 button(CAMERA) to ON.When the button is pressed and its indicator is lit, the[CAMERA] menu is displayed on the LCD panel.[1]GROUP ▼3 Press the F1 dial.The GROUP SELECT item is displayed.[1]GROUP ▼1.GROUP SELECT1Press the F1 dial.4 Turn the F2 dial, select the group, and thenpress the F2 dial.The remote cameras assigned to the group selected herecan be selected using the CAMERA STATUS/SELECTIONbuttons.