Panasonic AW-RP50E Operating Instructions Manual

Also see for AW-RP50E: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

29 (F)Connections Changing the camera numbersThe camera numbers which have been set by “Auto IPsetting” can be changed.They are changed by replacing the IP addresses of thecurrent camera numbers with the IP addresses of thecamera numbers to be changed.1 On the [SYSTEM] menu, select [CAM ASSIGN],and display [CAM1] to [CAM100]. Then selectthe camera number to be changed.2 Select the IP address of the remote camera forthe selected camera number.The tally indicator of the remote camera correspondingto the selected IP address lights.Operate the PAN/TILT lever, and check whether thecamera whose camera number is to be changed isbeing moved.The IP address that can be selected is the IP address ofthe camera number which has been set for “Network” forthe [CAM1] to [CAM100] item of [CAMERA CTL] on the[SYSTEM] menu.3 Press the F2 dial to enter the IP address.The IP addresses for the camera number of the changedestination and for the camera number of the changesource are switched over.1.IP:CAM1 ▼192.168.000.100When “ASSIGN” is displayed for the [CAM1] to [CAM100]item of [CAM ASSIGN] on the [SYSTEM] menu, theCAMERA STATUS/SELECTION buttons cannot beoperated, and the camera operations (IRIS, FOCUS, PT,ZOOM and CAMERA OSD) cannot be controlled.Note Changing the IP address of theswitcherThe IP address of the switcher which was set by “Auto IPsetting” can be changed.1 On the [SYSTEM] menu, select [SW IP ADR],and display [IP:SW]. Then change the IPaddress. Clearing the IP address controltablesAll the IP address control tables which have been set can becleared together.1 On the [SYSTEM] menu, select [AUTO SETUP],and display [AUTO SETUP]. Then select “ALLCLEAR”, and press the F2 dial to clear all thetables.1.AUTO SETUPALL CLEAR The “Serial” settings are not cleared.