28RQT9127Copying from an external device[RAM] [-R] [-RW‹V›] [+R] [+RW][RAM] When the “DV Auto Rec” function is used, programmes arerecorded as a title while at the same time chapters are created ateach break in the images and the playlist is created automatically.≥Turn off the unit and DV equipment before connecting.≥Select the type of audio recording from “Audio Mode for DV Input”in the Setup menu (➡ 61).≥When recording from DV equipment (e.g., digital video camcorder),you can record audio/video recordings from DV tape only.Preparation1 Turn off the main unit and DV equipment, then connect theequipment with the unit’s DV input terminal (➡ above).2 Turn on the main unit.≥When the output signal from the external equipment is NTSC,change the “TV System” to “NTSC” in the Setup menu (➡ 62).1 Turn on the DV equipment, and pauseplay at the point you want recording tostart.The following screen appears.≥When the screen is not displayed2 Press [2, 1] to select “Rec to DVD”and press [OK].3 Press [REC MODE] to select therecording mode.4 Press [2, 1] to select “Rec” andpress [OK].Recording starts.When recording finishesThe confirmation screen appears. Press [OK] to finish DV automaticrecording.To stop recordingPress [∫].[Note]≥If it becomes time for a timer recording to start while copying, therecording will start and the copying will stop.≥If video is copied from another piece of equipment to this unit, thenthe video quality will be degraded.≥External DV cannot be recorded to VHS.≥Only one piece of DV equipment (e.g., digital video camcorder) canbe connected to the unit via the DV input terminal.≥It is not possible to operate the unit from the connected DV equipment.≥The DV input on this unit is for use with DV equipment only. (Itcannot be connected to a computer, etc.)≥The DV equipment name may not be shown correctly.≥Depending on the DV equipment, the images or audio may not beinput properly.≥The date and time information on the tape of the DV equipment willnot be recorded.≥You cannot record and play simultaneously.DV automatic recording (DV Auto Rec)S VIDEOIN 2 VIDEO /MONO AUDIO RLS VIDEO VIDEO /MONO AUDIO RLAV2 INDRIVE SELECT RECCHCHOPEN/CLOSEEJECTCOPYINGCOPYINGThis unitDV equipmentDV cable(IEEE 1394,4-pin)After performing step 11 Press [DRIVE SELECT] to select the DVD drive.2 Press [FUNCTION MENU].3 Press [3, 4] to select “To Others” and press [OK].4 Press [3, 4] to select “DV Auto Rec” and press [OK].➡ Go to step 3 (➡below)If the DV automatic recording function does not work properly,check the connections and DV equipment settings, and turn theunit off and back on.If that does not work, follow the instructions for manualrecording (➡ 27).DV Auto RecRec to DVD CancelDV unit is connected.Record from the DV unit?OK RETURNSELECT