43RQT9127After performing steps 1–4 (➡ 42)§ Multiple editing is possible.After performing steps 1–6 (➡ 42)§ Multiple editing is possible.Title operationsDelete§[RAM] [-R] [-R]DL] [-RW‹V›] [+R][+R]DL] [+RW]Press [2, 1] to select “Delete” and press [OK].≥Once deleted, the recorded contents are lost and cannot be restored. Make certain before proceeding.≥The available recording space on DVD-R, DVD-R DL, +R or +R DL does not increase when you delete titles.≥Available recording space on DVD-RW (DVD-Video format) and +RW increases only when the last recordedtitle is deleted. It does not increase if other titles are deleted (➡ 22).Properties[RAM] [-R] [-R]DL] [-RW‹V›] [+R][+R]DL] [+RW] [-RW‹VR›]Information (e.g., time and date) is shown.≥Press [OK] to exit the screen.Enter Name[RAM] [-R] [-R]DL] [-RW‹V›] [+R][+R]DL] [+RW]You can give names to recorded titles.(➡ 46, Entering text)Set up Protection§Cancel Protection§[RAM] [+R] [+R]DL] [+RW]If set, this will protect the title from accidental deletion.Press [2, 1] to select “Yes” and press [OK].The lock symbol appears when the title is protected.Partial Delete[RAM](➡ below, For your reference)You can remove unnecessary part of the recording.1 Press [OK] at the start point and end point of thesection you want to delete.2 Press [3, 4] to select “Finish” and press [OK].≥Select “Next” and press [OK] to delete other sections.3 Press [2, 1] to select “Delete” and press [OK].Change Thumbnail[RAM] [-R] [-R]DL] [-RW‹V›] [+R][+R]DL] [+RW](➡ below, For your reference)You can change an image to be shown as the thumbnail picture in the TitleView.1 Press [1] (PLAY) to start play.2 Press [OK] when the image you want to use as athumbnail is shown.To change the thumbnailRestart play and press [3, 4] to select “Change”, then press [OK] atthe point you want to change.3 Press [3, 4] to select “Finish” and press [OK].Divide Title[RAM](➡ below, For your reference)You can divide a title into two.1 Press [OK] at the point you want to divide the title.2 Press [3, 4] to select “Finish” and press [OK].3 Press [2, 1] to select “Divide” and press [OK].To confirm the division pointPress [3, 4] to select “Preview” and press [OK]. (The unit plays 10seconds before and after the division point.)To change the division pointRestart play and press [3, 4] to select “Divide”, then press [OK] at thepoint where you want to divide the title.[Note]≥The divided titles retain the title name and CPRM property (➡ 81) of the original title.≥Video and audio just before and after the dividing point may momentarily cut out.Chapter operationsPropertiesNo.NameDate 26ARD11.10.2006 TimeRec time 12:190:30 (SP)MONDinosaurDIRECT NAVIGATOR Title VARD 10.10. FRI ARD 11.10.07 08DVD-RAMDIRECT NAVIGATOR Partial DeleteStartNextFinish0:43.21PLAY08End- -:- -.- - - -:- -.- -Start EndOKRETURNDVD-RAMDIRECT NAVIGATOR Change ThumbnailChangeFinish0:00.00- -:- -.- -Change08OKRETURNStart play and select the imageof a thumbnail.DVD-RAMDIRECT NAVIGATOR Divide TitlePreviewFinish0:43.21PLAY08Divide- -:- -.- -DivideOKRETURNDVD-RAMDelete Chapter§[RAM]Press [2, 1] to select “Delete” and press [OK].≥Once deleted, the recorded contents are lost and cannot be restored. Make certain before proceeding.≥Select “Combine Chapters” (➡ below) when you only want to delete the division point between chapters.(The recorded contents will not be deleted.)Create Chapter[RAM](➡ below, For your reference)Select the point where you want to start a new chapter while viewing thetitle.1 Press [OK] at the point you want to divide.≥Repeat this step to divide at other points.2 Press [3, 4] to select “Finish” and press [OK].Combine Chapters[RAM]Press [2, 1] to select “Combine” and press [OK].≥The selected chapter and following chapter are combined.For your reference≥Use Search (➡ 32), Time Slip (➡ 32) to find the desired point.≥To find the desired point correctly, use Slow-motion (➡ 32) and Frame-by-frame (➡ 32).≥To skip to the start or end of a title, press [:] (start) or [9] (end).DIRECT NAVIGATOR Create ChapterCreateFinish0:43.21PLAY08OKRETURNDVD-RAMEditing titles/chapters