Panasonic Diga DMR-EZ37 Operating Instructions Manual

Also see for Diga DMR-EZ37: Firmware instructions

Contents

25RQT8849NotesUp to 20 index signals can be searched in either direction.If you overshoot in either direction, press the opposite button tocorrect.For correct operation, make recordings of at least 5 minutes toensure that index signals are not spaced too closely together.VHS Index Search System (VISS)The unit automatically records special index signals on atape every time a recording is started (via [ REC], or ascheduled recording). The index search function makesuse of these index signals to help you find the beginningof a desired program quickly and easily.While stopped or during normal playor .– Each press increases the number of skips.– Press [ STOP] to cancel the search.S-VHS Quasi Playback (SQPB)This unit can play tapes recorded in S-VHS.Some picture noise may occur depending on the typeof tape used.It is not possible to fully obtain the high resolutionS-VHS is capable of.This unit cannot record in S-VHS.Advanced FeaturesNotesOnly works if there is at least 5 seconds blank space at the end ofthe program.When the tape reaches the end of the program, it willautomatically rewind to the beginning and play again.Repeat PlaybackDuring playback or while stoppedPLAYPress and hold for about 5 ormore seconds.– Repeat Playback goes on indefinitely until youcancel it.– The “RPt” indication appears on the unit’s display.– Press [ STOP] to stop play.TipsTo remove the noise from a paused picture:Start slow play ( 24), then adjust the tracking.Manual TrackingDuring playbackTRACKING/V-LOCKCHorTRACKING/V-LOCKCH– Repeat until the picture noise disappears.To return to auto tracking:TRACKING/V-LOCKCH(simultaneously).The unit usually makes tracking adjustmentsautomatically, but you may need to do it manually if noiseappears on a tape recorded on other equipment.Adjusting the playback pictureAdjust the vertical synchronization to stop the picturefrom shaking while paused.Vertical Locking AdjustmentNotesThis function may not work with some tapes.You can also adjust vertical synchronization with [CH , ] on themain unit.While pausedTRACKING/V-LOCKCHorTRACKING/V-LOCKCH– Repeat until the shaking stops.To return to the standard position:TRACKING/V-LOCKCH(simultaneously).NotesThis function may not work with some tapes.You can also adjust the tracking with [CH , ] on the main unit.