Panasonic Diga DMR-EZ37 Operating Instructions Manual

Also see for Diga DMR-EZ37: Firmware instructions

Contents

53RQT8849 Connection and SettingSetting the Channels and ClockPOWERDVD/VHSto turn the unit on.TRACKING/V-LOCKCHto select an RF output channel number 3.When the picture on the TV is poor, switch the TV tochannel 4. Also change this unit’s display to “CH 4”.When nothing is displayed, change the TV channel tovideo input. Then turn this unit’s display to “OFF”.Select LanguageSeleccione el idiomaSélection de languePress ENTERPulse ENTERAppuyer sur ENTEREnglishFrançaisEspañolLanguage:,  to select, then ENTERSelect TV type and press ENTER.(Please refer to Operation Instructionfor details)Aspect Ratio Selection4:3 TV16:9 Widescreen TVTV Aspect Ratio:,  to select “4:3 TV” or “16:9Widescreen TV” then ENTERWhen connecting to a 4:3 standard aspect TV:Select “4:3 TV”.When connecting to a 16:9 widescreen TV:Select “16:9 Widescreen TV”.The unit can be turned on faster, in about1 second. Please note that Quick Startmode slightly increases powerconsumption when the unit is off.(See Operation Instructions for details)Turn Quick Start on ?OnOffQuick Start SettingQuick Start Function:,  to select “On” or “Off”then ENTERDoes this unit get its TV signal via RF IN?Example: Antenna, Cable TV or Cable Box connected to theunit’s RF IN.YesNoAutomatic Clock and Channel SettingsAutomatic Clock and ChannelSettings:,  to select “Yes” or “No”then ENTERWhen connecting the cable from the wall (cable TV or antenna) tothe unit’s RF IN:Select “Yes”.The unit then displays the source selection screen ( 54).When not connecting the cable from the wall (cable TV orantenna) to the unit’s RF IN:Select “No”.The unit then displays “Set Clock Manually” screen ( 54,Manual Clock Setting).Tips“Quick Start” function ( 40)If you set Quick Start to on, youcan start recording to DVD-RAMabout 1 second after you press[ DVD/VHS POWER] to turn theunit on and then sequentially press[ REC].The following happens when you haveselected “On”.– Power consumption in standby modeincreases because power is suppliedto the unit.To return to the previous screenPress [RETURN].Preparation:Turn on the television and select channel 3.These are the first settings you make uponbuying the unit. You don’t need to make thesesettings again.POWERPOWERSLOW/SEARCHSCHEDULEENTERFUNCTIONSTV/VIDEOPAUSESTOP3216549870REC MODERETURNSUB MENUCM SKIPDIRECTNAVAIGATAAORDISPLAYAUDIORECDRIVESELECTF Rec STATUSCHAPTERCREATEINPUT SELECTCANCEL DELETECHCHPLAYVOLDVD/VHSVCR/TVTRACKING/V-LOCKSKIP/ INDEX REW FFTIME SLIP/ JET REWRESETContinued on next page