78RQT8849Error MessagesOn the Unit’s Display PageH , F(“ ” stands for a servicenumber.)An error has occurred. The number following “H” or “F” dependson the status of the unit. Check the items below and in theTroubleshooting Guide. If the service number still does notdisappear after the check, reset the unit ( 67, “To restore the unit ifit freezes”).−If the service numbers fail to clear, note the service numbers andcontact a qualified service person.−RC (“ ” stands for a number.) The remote control and main unit are using different codes. Changethe code on the remote control.67HARD ERR(“HArd” and “Err” are alternatelydisplayed.)If there is no change after turning the unit on and off, consult thedealer where the unit was purchased.−NO READ(“NO” and “REAd” are alternatelydisplayed.)The disc is dirty or badly scratched. The unit cannot record, play, oredit.65The disc may be incompatible or of poor quality. 62 to 64You have used a lens cleaner and it has finished operation. Press[ OPEN/CLOSE] on the main unit to eject the disc.3Displayed when the unit is started. This is not a malfunction. −The unit is carrying out its recovery process. You cannot operate theunit while “ ” is displayed.−FULL There are already 16 scheduled recording programs. Deleteunnecessary scheduled recording programs.18UNSUPPORT(“UNSUP” and “POrt” arealternately displayed.)You have inserted a disc the unit cannot play or record on. 62, 63UNFORMAT(“UNFOr” and “MAt” arealternately displayed.)You have inserted a new DVD-RW/+RW or a DVD-RAM/DVD-RW(DVD-Video format) recorded on other equipment.You can format the disc when the format confirmation screen isdisplayed.37U59 The unit is very warm.The unit switches to standby for safety reasons. Wait for about30 minutes until the message disappears.Reinstall the unit in an area with adequate ventilation. Do not blockthe cooling fan on the rear of the unit.−U61 There was a power failure or the AC power supply cord wasdisconnected while the unit was on. The unit is carrying out itsrecovery process. This process restores the unit to normal operation.The unit is not broken. Wait until the message disappears.−U88 There was something unusual detected with the disc whilerecording, playing or copying; there was a power failure or the ACpower supply cord was disconnected while the unit was on. The unitis carrying out its recovery process. This process restores the unitto normal operation. The unit is not broken. Wait until the messagedisappears.69U99 The unit fails to operate properly. Press [/I POWER] on the mainunit to switch the unit to standby. Press [/I POWER] on the mainunit again to turn the unit on.−