Initial setupBefore you beginConfirm the following before you begin.– Make sure you have installed the [HomeHawk] app on your mobile device– Make sure your wireless router and the access point are turned on and the access point’s LEDindicator is lit in amber or green– Make sure your access point is connected to your wireless router with an Ethernet cable– Make sure your mobile device is connected to the same wireless router as your access point– Make sure your mobile device can connect to the InternetNote:R If you have completed this procedure and want to register another mobile device to the access point,see “Registering other mobile devices to the access point”, Page 15.R If you experience trouble while performing this procedure, refer to the information in “Sometimes Icannot connect while at home”, Page 87.R For information about the setup for HD cameras, see page 57.Initial setup1 Start the [HomeHawk] app by tapping its icon (shown below).R The end-user license agreement is displayed the first time you start the app.2 Follow the on-screen instructions.3 Tap [Access Point + Front Door/Outdoor Camera(s)] wait for a while, and then follow theon-screen instructions.Access Point + Front Door/Outdoor Camera(s)R If the access point’s LED indicator lights in green, tap the green lit button, and then go to step 4.R If the access point’s LED indicator blinks in amber, tap the amber blinking button, and thenconnect the Ethernet cable between the access point and router. Next, follow the on-screeninstructions, wait for a while, and then check the color of the LED lights again.14System setup