DISA Intercept Routing—No AnswerIf a destination is not available to answer a DISA call within a preprogrammed time period (DISA Intercept time)after the call is reached, the call will be redirected to the programmed destination by the Intercept feature.If the intercept destination is not available to answer the call within a preprogrammed time period (DISADisconnect Time after Intercept) after the DISA Intercept time expires, the call will be disconnected.10.3 PBX Configuration—[2-3] System—Timers & Counters—DISA / Door / Reminder / U. Conf→ DISA—Intercept Timer—Day, Lunch, Break, Night→ DISA—Disconnect Timer after Intercept® 12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings—InterceptDestination— Intercept Destination—When called party does not answer—Day, Lunch, Break, Night® 12.2.1 PBX Configuration—[4-2-1] Extension—Portable Station—Extension Settings—InterceptDestination— Intercept Destination—When called party does not answer—Day, Lunch, Break, NightWalking COS Through DISAIf the caller performs Walking COS (extension number and PIN entry) while hearing a DISA message, thesecurity mode can be temporarily changed to No Security mode (® 2.7.5 Walking COS). After performingWalking COS, the following features are available, using the settings of the specified extension:• Intercom call• TIE line call• Trunk call• Call Forwarding (FWD)/Do Not Disturb (DND) setting (® 2.3 Call Forwarding (FWD)/Do Not Disturb (DND)Features)• Incoming Call Distribution Group Log-in/Log-out (® 2.2.2.7 Log-in/Log-out)• Absent Message setting (® 2.20.2 Absent Message)• Extension Dial Lock (® 2.7.3 Extension Dial Lock)• Time Service Switching Mode (® 5.1.4 Time Service)NoteWhen making a trunk call using Walking COS through DISA, the CLIP number for that call will be that ofthe extension seized by Walking COS. (® 4.1.2.2 Calling/Connected Line Identification Presentation(CLIP/COLP))DISA Automatic Walking COSRegistered outside destinations such as cellular phones can be automatically recognised as PBX extensionswhen calling through DISA. When the Caller ID of a received trunk call matches an entry in the System SpeedDialling Table, the calling telephone is given Walking COS authorisation as assigned to the corresponding CLIdestination extension. Therefore, the "CLI destination" setting in the System Speed Dialling Table is used hereto specify the target extension that the calling telephone will be recognised as for Walking COS.[Programming Example of DIL Table]Trunk No.CLI DestinationDay Lunch ... Day Lunch ...01 Disable Disable ... 5801(DISA)5801(DISA) ...: : : : : : :"CLI" must be set to Disable, to allow incoming calls to be received by DISA.[Programming Example of System Speed Dialling Table]Feature Guide 1792.16.1 Direct Inward System Access (DISA)
