Panasonic KX-TG8052C Operating Instructions Manual

Making/Answering Calls17Making calls1 Lift the handset and dial the phonenumber.L To correct a digit, press {CLEAR}.2 Press {C} or {CALL}.3 When you finish talking, press {OFF} orplace the handset on the base unit orcharger.Using the speakerphone1 Dial the phone number and press {s}.L Speak alternately with the other party.2 When you finish talking, press {OFF}.Note:L For best performance, use thespeakerphone in a quiet environment.L To switch back to the receiver, press{s}/{C}.Adjusting the receiver or speakervolumePress {^} or {V} repeatedly while talking.Making a call using the redial listThe last 5 phone numbers dialed are stored inthe redial list (each 48 digits max.).1 {REDIAL} or {4} REDIALL If there is a new message in theanswering system, {REDIAL} is notdisplayed. (KX-TG8061 series: page3)2 {r}: Select the desired phone number.3 {C}Erasing a number in the redial list1 {REDIAL} or {4} REDIAL2 {r}: Select the desired phone number.s {ERASE}3 {r}: “Yes” s {OK} s {OFF}Pause (for PBX/long distance serviceusers)A pause is sometimes required when makingcalls using a PBX or long distance service.When storing a calling card access numberand/or PIN in the phonebook, a pause is alsoneeded (page 21).Example: If you need to dial the line accessnumber “9” when making outside calls with aPBX:1 9 s {PAUSE}2 Dial the phone number. s {C}Note:L A 3.5 second pause is inserted each time{PAUSE} is pressed. Repeat as needed tocreate longer pauses.Answering callsWhen a call is being received, the ringerindicator flashes rapidly.1 Lift the handset and press {C} or {s}when the unit rings.L You can also answer the call bypressing any dial key from z to 9, *,or y. (Any key answer feature)2 When you finish talking, press {OFF} orplace the handset on the base unit orcharger.Auto talkYou can answer calls simply by lifting thehandset off the base unit or charger. You donot need to press {C}. To turn this feature on,see page 24.Adjusting the handset ringer volume■ While the handset is ringing for anincoming call:Press {^} or {V} repeatedly to select thedesired volume.■ Programming the volume beforehand:1 {MENU} (middle soft key) y16z2 {r}: Select the desired volume.3 {OK} s {OFF}TG80xxC(e).book Page 17 Friday, June 10, 2011 2:06 PM