Panasonic KX-TG8052C Operating Instructions Manual

Useful Information42Battery rechargeMaking/answering calls, intercom*1 KX-TG8061 series: page 3Problem Cause/solutionThe handset beeps and/or dflashes.L Battery charge is low. Fully charge the batteries (page11).I fully charged the batteries, but– d still flashes,– the operating time seems tobe shorter.L Clean the battery ends (S, T) and the charge contactswith a dry cloth and charge again.L It is time to replace the batteries (page 11).Problem Cause/solution_ is displayed. L The handset is too far from the base unit. Move closer.L The base unit’s AC adaptor is not properly connected.Reconnect AC adaptor to the base unit.L The handset is not registered to the base unit. Register it(page 29).Noise is heard, sound cuts inand out.L You are using the handset or base unit in an area withhigh electrical interference. Re-position the base unit anduse the handset away from sources of interference.L Move closer to the base unit.L If you use a DSL/ADSL service, we recommendconnecting a DSL/ADSL filter between the base unit andthe telephone line jack. Contact your DSL/ADSL providerfor details.The handset does not ring. L The ringer volume is turned off. Adjust the ringer volume(page 17).L Night mode is turned on. Turn it off (page 27).The base unit does not ring.*1 L The ringer volume is turned off. Adjust the ringer volume(page 18).I cannot make a call. L The dialing mode may be set incorrectly. Change thesetting (page 15).L The handset is too far from the base unit. Move closerand try again.L Another unit is in use. Wait and try again later.L Answering system is being used. *1 Wait and try againlater.I cannot make long distancecalls.L Make sure that you have long distance service.TG80xxC(e).book Page 42 Friday, June 10, 2011 2:06 PM