Programming284 Enter the desired hour and minute youwish to end this feature. s M5 {ic}L When the night mode is set, f isdisplayed.Changing the start and end time1 1 (middle soft key) (2372 Continue from step 3, „Turning nightmode on/off”, 27. oldal.Setting the ring delayThis setting allows the handset to ring duringnight mode if the caller waits long enough.After the selected amount of time passes, thehandset rings. If you select “Nincscseng.”, the handset never rings duringnight mode.1 1 (middle soft key) (2392 {r}: Select the desired setting. s Ms {ic}Selecting categories to bypass nightmode1 1 (middle soft key) (2412 Select your desired categories bypressing 1 to 9.L “Q” is displayed next to the selectedcategory numbers.L To cancel a selected category, pressthe same dial key again. “Q”disappears.3 M s {ic}Changing the handset nameEach handset can be given a customisedname (“Bob”, “Kitchen”, etc.). This is usefulwhen you make intercom calls betweenhandsets. You can also select whether or notthe handset name is displayed in standbymode. The default setting is “NEM”. If youselect “IGEN” without entering any handsetname, “Kézibesz. 1” to “Kézibesz. 6”is displayed.1 1 (middle soft key) (1)42 Enter the desired name (max. 10characters; 45. oldal).L If not required, go to step 3.3 M4 {r}: Select the desired setting. s M 2times5 {ic}Incoming call barring (Caller IDsubscribers only)This feature allows the unit to reject callsfrom specified phone numbers that you donot want to answer such as junk calls.When a call is received, the unit does not ringwhile the caller is being identified. If thephone number matches an entry in the callbarred list, the unit sends out a busy tone tothe caller, and then disconnects the call.Fontos:L When the unit receives a call froma number that is stored in the call barredlist, the call is logged in the caller list (35.oldal) with 7 after the call is disconnected.Storing unwanted callersYou can store up to 30 phone numbers in thecall barred list.Fontos:L You must store the phone number with anarea code in the call barred list.■ From the caller list:1 {<} (y)2 {r}: Select the entry to be barred. sM s I3 {r}: “Bejövő szám tiltása” sM4 {r}: “IGEN” s M s {ic}■ By entering phone numbers:1 1 (middle soft key) (217 sm2 Enter the phone number (24 digitsmax.). s ML To erase a digit, press ^.3 {ic}TG8611PD(e-hg).book Page 28 Friday, March 18, 2011 1:31 PM