Panasonic KX-TG8611PD Operating Instructions Manual

Useful Information49Programmable settingsBattery rechargeMaking/answering calls, intercomProblem Cause/solutionThe display is ina language I cannotread.L Change the display language (13. oldal).While programming, thedisplay returns tostandby mode.L A call matching an entry in the call barred list is beingreceived. Wait and try again later.I cannot activate the ecomode.L You cannot set eco mode when you set the repeater mode“BE”. If required, set the repeater mode to “KI” (34. oldal).I cannot registera handset to a base unit.L The maximum number of base units (4) is already registeredto the handset. Cancel unused base unit registrations fromthe handset (33. oldal).L The maximum number of handsets (6) is already registered tothe base unit. Cancel unused handset registrations from thebase unit (33. oldal).L You entered the wrong PIN. If you forget your PIN, contact anauthorised service centre.Problem Cause/solutionThe handset beepsand/or ) flashes.L Battery charge is low. Fully charge the batteries (8. oldal).I fully charged thebatteries, but– ) still flashes or– the operating timeseems to be shorter.L Clean the battery ends (S, T) and the charge contacts witha dry cloth and charge again.L It is time to replace the batteries (8. oldal).L After registering your Bluetooth headset to your handset, thebattery life of your handset will decrease. If you do not usea Bluetooth headset, it is better to turn off the Bluetoothsetting.Problem Cause/solution_ is displayed. L The handset is too far from the base unit. Move closer.L The base unit’s AC adaptor is not properly connected.Reconnect AC adaptor to the base unit.L The handset is not registered to the base unit. Register it (33.oldal).L Activating one touch eco mode reduces the range of the baseunit in standby mode. If required, turn eco mode off (13.oldal).TG8611PD(e-hg).book Page 49 Friday, March 18, 2011 1:31 PM