![Panasonic KX-TS4300 Operating Instructions Manual Manual pdf 64 page image](https://manuals-archive2.s3.amazonaws.com/5446007/5bb2a0cb4bff2ca65f45d4bbbd4c060764f.jpg)
Answering system64 For assistance, please visit http://www.panasonic.com/phonehelp4 Select the desired setting, then press{MENU/SET}.5 Press and hold {MENU/SET} toreturn to standby mode.Note:L To return to the previous menu, press{<}.For Voice Mail service subscribersIf you subscribe to a flat-rate servicepackage that includes Caller ID, CallWaiting, Voice Mail, and unlimited local/regional/long distance calls, please notethe following:L To use the Voice Mail service providedby your telephone service providerrather than the unit’s answeringsystem, turn off the answering system(see “Turning the answering systemon/off ” on page 57).L To use this unit’s answering systemrather than the Voice Mail serviceprovided by your telephone serviceprovider, please contact yourtelephone service provider todeactivate your Voice Mail service.If your telephone service providercannot do this:– Set this unit’s “TAD Ans. Delay”setting so that this unit’s answeringsystem answers calls before theVoice Mail service of your telephoneservice provider does (see “TADanswer delay” on page 57). It isnecessary to check the time requiredto activate the Voice Mail serviceprovided by your telephone serviceprovider before changing thissetting.– Change the time of the Voice Mailservice so that the answeringsystem can answer the call first. Todo so, consult your telephoneservice provider.Caller’s message lengthYou can change the maximum messagerecording time allotted to each caller.The default setting is “Unlimited”.“Greeting Only”: The unit plays thegreeting message (“Hello, we are notavailable now. Thank you for calling.”)but does not record caller messages.“1 Minute”: The caller can record themessage up to 1 minute.Important:L Make sure that the unit is in standbymode.1 Press {MENU/SET}.2 Select “AA/TAD Setup”, then press{MENU/SET}.3 Select “Message Length”, thenpress {MENU/SET}.4 Select the desired setting, then press{MENU/SET}.5 Press and hold {MENU/SET} toreturn to standby mode.Note:L To return to the previous menu, press{<}.Toll Saver=Off[SET]:Save[V/^]:Change➔Message LengthCall ScreeningIntercept Call[V/^]:ScrollMessage Length=Unlimited[SET]:Save[V/^]:Change