B7 SYSTEM ADMINISTRATION - HARDWARE SETTINGSSYSTEM ADMINISTRATOR'S GUIDE 251To program the following 10 Parameters on the following page, use the Special Commands andDial Codes listed below. Up to 12 digits can be set for each parameter.D: DisconnectingF: Hook FlashR: Ringback Tone DetectionS: Silence DetectionT: Dial Tone DetectionW: Wait for 1 sX: Extension dialingA: Answer1-9, 0, , #: Dial CodesTable 68Parameter Value Range(Default)Description/FunctionOperatorTransferSequence(FX)This sequence is performed by the VPS when transferringcalls to the operator's extension.ExtensionTransferSequence(FX)This sequence is performed by the VPS when transferringcalls to any extension except the operator's.AlternateExtensionTransferSequence(FX)This sequence is performed by the VPS when transferringcalls to extensions in the Alternate Extension Group.ReconnectSequence onBusy(F)If an extension is busy, this sequence allows the VPS toreconnect to the caller.ReconnectSequence onNo Answer(F)If the extension does not answer, this sequence allows theVPS to reconnect with the caller.ReconnectSequence onRefuse Call(F)This sequence is performed by the VPS to retrieve a callplaced on hold after the extension (in the Call Screeningmode) has refused to accept it.Light-OnSequence forMessageWaiting Lamp(None)The dialing sequence that the VPS must perform to enablethe Message Waiting Lamp at an extension.Light-OffSequence forMessageWaiting Lamp(None)This is the dialing sequence that the VPS must perform todisable the Message Waiting Lamp at an extension.
