3.2 PBX PARAMETERS AND PORT SETTINGSINTEGRATING THE VPS WITH PANASONIC KX-T PHONE SYSTEMS 49Digit Translation Table ParametersThese parameters allow PBXs that have a fixed Follow-on ID sequence to be used with the KX-TVS50/80. For example, a Follow-on ID sequence of [ 101] can be changed to [#6101]by using these parameters.• Inter-Digit Time-Out: This parameter defines the interval of incoming signals (Follow-on ID) from the PBX to the VPS. The Digit Translation Table applies the digits receivedwithin this time to translation.• Input-Output (up to 8 alphanumeric characters): When the system receives digitswithin the inter-digit time, it checks them against the input table. If they are found, thesystem utilizes the output digits in their place.7Forwarded to VoiceMail (Busy)The extension dialed is forwarded to Voice Mail and noother Voice Mail ports are available to accept the call. (Thissignals the Voice Mail port [usually Auto-Attendant] to letthe caller to leave a message.)8 Forwarded to Extn. The extension dialed is forwarded to another, non-VoiceMail extension.9 Confirmation Tone The Message Waiting Lamp On or Message Waiting LampOff code is dialed successfully.#9 Disconnect The caller disconnects. The central office must set a CPCsignal to the PBX line for this signal to work for CO calls.Table 11Code(default)Call State Sent to the Voice Mail Port When...The Remainder of this section consists of step-by-step guides for software verificationand programming of the recommended Panasonic PBX systems.If you have any problems as you go through this section, please call Panasonic TechnicalSupport at (201) 392-4843
