4.4 COMMON DIGITAL INTEGRATION FEATURES AND SETUP PROCEDURES86 INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOG PBX AND KX-TD DIGITAL PBX1. Enter Station Programming:For KX-TA624With the phone on-hook, Set the MEMORY switch to "PROGRAM".(Display changes to PITS-PGM Mode.)For KX-TD seriesEnter PITS programming:a. With the phone on-hook, Press the PROGRAM button.b. Dial [99]. (Display changes to PT-PGM Mode.)2. Press the code for the mode you want this phone to have.Hands-Free = #11(for KX-TA624) or 71 (for KX-TD series)Private = #12 (for KX-TA624) or 72 (for KX-TD series)Screen output: Hands-Free or Private3. Press STORE.4. Exit the program mode:For KX-TA624Set the MEMORY switch to "SET".For KX-TD seriesPress the PROGRAM button or lift the handset.5. Repeat these steps at each telephone.For the KX-TD series only:A single-line telephone that is connected to the same extension as a proprietary telephone canalso be used to monitor an incoming message. Be sure that Live Call Screening on theconnected proprietary telephone has been activated. This feature is useful when you are usinga cordless telephone. The handset sounds an alert tone to let you know that a message is beingrecorded. To intercept the call, flash the hook.4.4.4 Live Call Screening Button AssignmentFor the Live Call Screening feature to work at an extension, the extension must have an LCSbutton on it and the button must be lit at the time of the message. This key must be either aDSS/BLF or CO key (must have a lamp). Follow the procedure below to assign an LCS buttonon an extension. (This is a station level program and should be done at each individual phone.)1. Enter Station Programming:For KX-TA624With the phone on-hook, Set the MEMORY switch to "PROGRAM".(Display changes to PITS-PGM Mode.)For KX-TD seriesa. With the phone on-hook, Press the PROGRAM button.b. Dial [99]. (Display changes to PT-PGM Mode.)2. Press the desired FLEXIBLE (CO or DSS/BLF) button you want to assign as the LCSbutton.Conditions: None
