4.3 CONNECTING THE KX-TVS50/80 WITH THE PANASONIC KX-TD816, KX-TD1232 AND KX-TD30876 INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOG PBX AND KX-TD DIGITAL PBX11. Start up completed.a) The Power Indicator light stops blinking when the start-up has been successful. (Thedelay varies according to the system's condition.)b) "**ON LINE MODE**" is displayed.c) System prompt [>] is displayed on the screen. To enter system administration, PressENTER. All parameters can be set through the menu-driven program.12.Go to the System Administration Top Menu. Type [5] and Press ENTER, or Type [3] thenQSET and Press ENTER for Quick Setup and follow the Auto Configuration Instructions.Set the DIP switch to position 0 after initialization is complete.4.3.2 KX-TD1232 Software Verification and Programming forDigital Integration via the Operating and Maintenance ToolFollow these steps after communication between the KX-TD1232 and the programmingsoftware has been established. Refer to the Operating and Maintenance manual forconnection information.1. Check the software version.a) Go to the Main Menu. Press the ALT key and the letter [V] at the same time.The PBX is a KX-TD series but doesnot have the proper level of softwarerequired to support DPT Integration.Contact National Parts Centerat 1-800-833-9626or use Inband Integration underhardware settings.The PBX is not programmed properlyto support DPT Integration.Do required integrationprogramming as described inthis chapter.TEST: Press the INTERCOM button and then [165]. If the VPSanswers, you have a DPT connection.The required programming is complete and the VPS and KX-TD1232 should be able tocommunicate through Digital Integration.When running the Quick Setup command (Section 5 CUSTOMIZING THE SYSTEM) fromthe VPS, the PBX transmits the station information automatically. This saves time whenprogramming the VPS.Table 16Cause Action
