Before using89VQT1A48ª To cancel Quick Start1 Set [SETUP] >> [QUICK START] >> [OFF].(-94-)≥If the [OFF/ON] switch is set to [OFF] while theunit is in quick start standby, the power turns off.≥If the standby continues for approx. 30 minutes,then the status indicator will go off and thecamera will be completely turned off.≥In the following cases, quick start is cancelledand the power turns off.≥When the Mode dial is moved.≥When the battery or AC adaptor is removed.≥When both the tape and card are removedwhile using the battery in Tape RecordingMode.≥When the card is removed while using thebattery in Card Recording Mode.≥When the camera is quick-started with the whitebalance on automatic, it may take some timeuntil the white balance is adjusted if the scenebeing recorded has a light source different fromthe scene last recorded. (When the colour nightview function is used, however, the whitebalance of the scene last recorded is retained.)≥If the power is turned on in quick start standby,the zoom magnification becomes 1k and thepicture size may differ from what it was beforequick start standby.≥If [POWER SAVE] (-137-) is set to [5 MINUTES]and the unit automatically goes into quick startstandby mode, set the [OFF/ON] switch to[OFF], then to [ON] again. Also, close the LCDmonitor and retract the viewfinder and thenopen the LCD monitor or extend the viewfinderagain.Inserting/removing a cassette1 Fit the AC adaptor or the battery and turn onthe power.2 Slide the [OPEN/EJECT] lever and open thecassette cover.≥When the cover is fully opened, the cassetteholder will come out.3 After the cassette holder is opened, insert/remove the cassette.≥When inserting a cassette, orient it as shownin the figure, and then securely insert it as faras it goes.≥When removing, pull it straight out.4 Push the [PUSH] mark 1 in order to closethe cassette holder.≥The cassette holder is housed.5 Only after the cassette holder is completelyhoused, close the cassette cover tightly.OPEN/EJECTPUSH1