57Adjustments and Settings for Recording : Setting the Electronic ShutterAdjustments and Settings for RecordingThe shutter speed in any shutter mode is set using theSHUTTER switch.In SYNCHRO SCAN/SYNCHRO SCAN2 mode, shutterspeed can be switched easily, using the SYNCHRO SCANadjustment buttons (+/–) on the side panel.Note that the range of selectable shutter speeds may be pre-defined; whether or not to use the SYNCHRO SCAN modemay be determined through the and screens. These screens are found inthe CAM OPERATION page.The selected shutter speed is retained even if the unit isturned off.1 Press the SHUTTER switch, positioned at [ON], towards[SEL].a. SHUTTER switch2 Once more, press the SHUTTER switch towards [SEL].Repeat this switchover until the desired mode or speedappears in the viewfinder screen.If all modes and speeds are available, the displaychanges in the following order:See [Viewfinder Screen Status Displays] (page 76).¡NoteWhen recording using VFR, set the shutter speed to 1/60 or1/100 to allow the recording to continue without any changein brightness when the frame rate is changed mid-waythrough recording.Setting the Shutter Mode and Speed aViewfinder displays relating to the shutterPOSITION1 POSITION2 POSITION3 POSITION4 POSITION5 POSITION6Normal modeSYNCHRO SCANmodeSYNCHRO SCAN2mode
