Panasonic PT-50DL54 Operating Instructions Manual

Also see for HDTV DLP PT-60DL54: Technical guide

Contents

Panasonic PT-50DL54 Operating Instructions Manual Manual pdf 4 page image

2 zIMPORTANT I NFORMATIONENGLISHFCC Declaration of ConformityResponsible Party:Matsushita Electric Corporation of AmericaOne Panasonic Way, Secaucus, NJ 07094Contact Source:Panasonic Consumer Electronics Company1-800-211-PANA (7262)E-mail: http://www.panasonic.com/contactinfoFCC InformationThis equipment has been tested and found to comply withthe limit for a Class B Digital Device in accordance with thespecifications in Part 15 of the FCC Rules. The limits aredesigned to provide reasonable protection against radioand television interference in a residential installation. Thisequipment generates, uses and can radiate radiofrequency energy and, if not installed and used inaccordance with the instructions, may cause harmfulinterference to radio communications. However, there is noguarantee that interference will not occur in a particularinstallation.If this equipment does cause interference to radio ortelevision reception (which you can determine by turningthe equipment off and on), try to correct the interference byone or more of the following measures.• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and thereceiver.• Connect the equipment into an outlet on a circuitdifferent from that which the receiver is connected.• Consult the dealer or an experienced radio/TVtechnician for help.Industry Canada InformationThis Class B digital apparatus complies with CanadianICES-003.Important Information when using theProjection TVReflection of external lightThe DLP™ Projection Television should be installed so thatexternal light shining on the screen is minimized. If sunlightor any bright light shines directly onto the screen, somepart of the screen may appear white, whether theProjection Television is on or off. This is not a defect.Cooling Fan InformationThis Projection Television has a fan for cooling the built-inlamp. After turning the set off, the fan will continue coolingthe lamp for about one minute.Note: During the lamp cooling process you may hear sounds from thefan. This is not a defect, the sound will stop after one minute.If the set is turned back on before the fan stops or the lampis not cool enough, it may take a while to display a normalpicture. This is not a defect.Screen may appear white fromreflection of external light.