Panasonic PT-EX500U Operating Instructions Manual

Contents

Panasonic PT-EX500U Operating Instructions Manual Manual pdf 34 page image

34 - ENGLISHGetting StartedConnectionsBefore connecting to the projectorRead carefully the instruction manual for the device to be connected.zTurn off the power switch of the devices before connecting cables.zIf any connection cable is not supplied with the device, or if no optional cable is available for connection of thezdevice, prepare a necessary system connection cable to suit the device.Video signals containing too much jitter may cause the images on the screen to randomly wobble or wafture.zIn this case, a time base corrector (TBC) must be connected.The projector accepts the following signals: VIDEO, S-VIDEO, analogue-RGB (with TTL sync. Level) andzdigital signal.Some computer models are not compatible with the projector.zWhen using long cables to connect with each of equipment to the projector, there is a possibility that the imagezwill not be output correctly unless a compensator is used.For details on what video signals the projector supports, see “List of compatible signals”. (z Æpages 109 to 113)Connecting exampleAnalog Out Signal TableInput terminal and Input signals Monitor OutInput 1RGB RGB(PC analog) YESRGB(Scart) NODVI-D DVI-D NODVI-D(HDCP) NOHDMI HDMI NOInput 2G, B ,R, SYNC/HD, VD RGB YESVIDEO Video NOY, PB/CB, PR/CR Y, Pb/Cb, Pr/Cr NOInput 3Y, PB/CB, PR/CR Y, Pb/Cb, Pr/Cr NOS-VIDEO S-video NOVIDEO Video NOAttentionWhen connecting with a video deck, be sure to use the one with a built-in time base corrector (TBC) or use a TBC between the projectorzand the video deck.If nonstandard burst signals are connected, the image may be distorted. If this is the case, connect a TBC between the projector and thezvideo deck.NoteWhen using an HDMI cable, check that it is compliant with the HDMI standard. Using a cable that is not compliant with the HDMI standardzmay result in problems such as the image cutting out or not appearing.When connecting the 1 080p signal using HDMI, use a cable compliant with 1 080p signal.This projector does not support the Viera link (HDMI).zFor the specifications of the RGB signals that can be applied from the PC, refer to “List of compatible signals”. (z Æpages 109 to 113)Computer Audio systemVideo deck(TBC built-in)Blue ray diskplayer withHDMI terminalBas